Advanced solid state electronics monitor your boat's systems and are constantly working to increase performance and economy. The system can be used in new or retrofit installations. The tabs are automatically put down before taking off to reduce bow rise and time to plane. Once the boat is on plane it is automatically leveled and held there. It's that simple! Setup is simple and it can use some or all of the data from other devices such as GPS speed, engine RPM, fuel consumption, etc. to constantly maintain optimal running angles every time. Two preset manual positions can be stored for such things as rough water or different speeds. A special "hold" feature maintains the boat's planing position until it's powered off. Manual override is also simple; just tap the up or down buttons. All this is controlled from a single 6" x 6" x 2" fully submersible box that contains three gyros and three accelerometers with waterproof connections and components. Plug and play illuminating key pad control with deutsch connection. Interfaces with NMEA 2000 devices to show position information on other devices or to get information from them.
The Auto Glide system requires the installation of the NMEA 2000 GPS which is included in the kits. You may also install these kits to your existing NMEA 2000 GPS network but it is strongly recommended to install our NMEA 2000 GPS as a back-up. If your boat is equipped with Mercury's SmartCraft system, we recommend connection with adapter cable 30246001 for additional features, but we still recommend that you also install the included NMEA 2000 GPS antenna.
Boat Must Be Equipped With Lenco Electric Trim Tabs
12 and 24 volt compatible
Fast, easy installation
All plug & play connections
All waterproof, solid state components
Quick response. Built-in retractor for trim tabs in auto mode
Reads SmartCraft, NMEA 2000 & J1939 dataSee Lenco's website at www.lencoautoglide.com for complete product descriptions, part number selection help, installation instructions, and operating instructions.
Description : For Single Actuator Per Trim Tab System
The Auto Glide system requires the installation of the NMEA 2000 GPS which is included in the kits. You may also install these kits to your existing NMEA 2000 GPS network but it is strongly recommended to install our NMEA 2000 GPS as a back-up. If your boat is equipped with Mercury's SmartCraft system, we recommend connection with adapter cable 30246001 for additional features, but we still recommend that you also install the included NMEA 2000 GPS antenna.
Boat Must Be Equipped With Lenco Electric Trim Tabs
12 and 24 volt compatible
Fast, easy installation
All plug & play connections
All waterproof, solid state components
Quick response. Built-in retractor for trim tabs in auto mode
Reads SmartCraft, NMEA 2000 & J1939 dataSee Lenco's website at www.lencoautoglide.com for complete product descriptions, part number selection help, installation instructions, and operating instructions.
Description : For Single Actuator Per Trim Tab System
Related Products
Tags: Auto Glide Boat Control Aftermarket Kit For Lenco Trim Tab Systems